Introduction:
The article describes the configuration of comRF for the Connection to guard.
There are 2 different types of comRF sticks:
- Standard comRF , Example for Declaration on the nameplate on the device "custo comRF ER2012 00584"
- comRF Long range (higher radio range) Example for Declaration on the nameplate on the device "custo com RF LR ERL2016 00084", "LR" means Long
The set up of the radio setting takes place only once and is then valid for all comRF sticks. The connection between guard and COMRF is automatically created at the start of the "New Exercise" button.
For a stable radio quality an N + 1 connection is recommended, that means for every training place a comRF stick plus an additional one.
Example: 8 training places require 9 comRF sticks.
When using USB hubs (more than 2 comRF), it is important to use them with active power supply and to use USB cables with 1m or more active USB cables!!
For Attention!!
The radio range and quality depends on several points:
- guard and comRF must always have line of sight
- in large rooms, the comRF are fixed to the ceiling
Conditions:
- Install Driver from comRF see https://www.customed.de/docs/x/SgG Section: "Available Drivers" => "custo med Devices Driver"
- Connect all comRF stick to the USB Port from PC or USB-Hub
Configuration sequence:
Enter Page Setting from comRF with Steps 1-3
Here is the display of the comRF sticks in default setting with a data rate of 2 Mbps and a connection of 1 comRF with 6 guards.
next Step, 1: Enter Page " internal Radio Settings", 2: set the Radio data rate of "250Kbs" and 3: set the used Radio channels of 1 Channel (1comRF of 1 guard)
In exceptional cases: 1 Channel guard can be set to Maximum 6 Channels and 3 Channel guard to Maximum 2 Channels.
and click "ok"
Result for two Place Rehab:
The data rate at number 1 remains at 2Mbps.
This comRF manages the connection between guard and comRF, the others with 250 Kbps are each connected to a guard.