Page History

Standard the er2100 Treadmill is setup with the USB port activated
In case you would like to change this you have to follow the procedure below.

Warning!

In case you are making mistakes in this procedure the treadmill might up ending not working.

Setting up communication port of the er2100

1. To enter the terminal application of the communication interface module (CIM) from the treadmill, the following
   procedure must be carried out:
2.  Connect a USB- or straight serial cable to connect to the communication interface
   module.
3.  You can use a terminal tool such as HyperTerminal or Terra Term.
4. We use in our example Tera Term, the treadmill is connected to COM3 ( you can check for the correct COM port in the device manager of Windows)

...

9. Now switch on the treadmill and immediately press (Ctrl + Break) for Hyperterminal and (Alt-b) for Tera Term on the key board of the computer,

...

Select communication protocol:

(Current selection: 1)
1) Lode Treadmill
2) Trackmaster
3) Woodway
4) HP Cosmos(backspace: back)
#>

12. Select the baud rate

Select baudrate:
(Current selection: 0)
0) Default1Default
1) 56k6256k6
2) 38k4338k4
3) 19k2419k2
4) 960059600
5) 480064800
6) 2400
(backspace: back)
#>

13. Select conversion Miles/hour to Kilometer/hour

Select in/out units:
(Current selection: 0)
0) Default1Default
1) kmph/kmph2kmph
2) mph/mph3mph
3) kmph/mph4mph
4) mph/kmph
(Backspace: back)
#>


Global communication timeout:
(Current selection: 0)
0) Disable
1) Enable



Save settings? (y/n)
(backspace: back)
#>y

Settings saved. Please restart device



14. After the settings have been saved the treadmill needs to be restarted to let the new settings take effect.