Introduction:
The article describes, how can i activate an configure the maintenance intervall
Basic:
order the keyoption "Maintenance":
Configure the Maintenance Intervall:
- open the webepage https://www.customed.de/service/Maintenance-Code-diag-5x,603
(1) Click the Link "Maintenance Code diag 5.x" (2) Input the Keynumber and Click (3) "Check"
2. generate the maintence code:
(1) Input the Expiration Date (2) available the Warning Level (see table maintenance level) (3) Click "create"
Maintenance Level
| Step | Definition | Increase to next level (when maintenance interval has expired) |
|---|---|---|
| 0 | No notice, maintenance interval has not yet expired | No automatic increase (note only in the info dialog) |
| 1 | Notice when starting the program | after another 14 days |
| 2 | How 1 and additionally when calling up a project | after another 14 days |
| 3 | Like 2 and additionally with every printout and export | after another 30 days |
| x | Maximum warning level according to the setting | after another 30 days (but has no further effects) |
3. automatic key generation:
webpage with Maintenance Code
and automatic generate a E-Mail with the same information:
4. Input and activate the Maintenance Intervall in custo diagnostic
start custo diagnostic (1) System (2) System (3) Maintenance (4) Input the Maintenance Code (example from this page "F05D3F6C74") and Click of the keybord "Enter" (5) Result you can see "Next data" and the "Warning Level"