General
Since version 4.6.2 / 4.7, two different types of telemetric training are supported in the Rehab module (note, not in the Telemetry module!). The main differences are:
| Exercise type | Description |
|---|---|
| telemetric exercise type with Profile |
|
| telemetric exercise type without Profile |
|
Display mode of telemetric exercise
An active telemetric exercise in Rehab, no matter which variant, always indicated with the label Telemetry in the top right-hand corner of the coordinate system or 'telemetry exercise' is displayed on the left-hand side below the training overview area.
Switching between classic reha and telemetric exercise
By default, the rehab module always works with a connected device. On the one hand you can switch off the connected training device for ever or on the other hand you can switch it off temporarily. The possibility of temporary switching of the training device can be set in 1.20 under Settings → Reha → General → Menu/Functions → Additiona settings for exercise stations → Operations.
If the setting is set, the user can switch between the classic rehabe exercise with connected device and telemtrioc exercise without any connected devide individual for each exercise station. This can be done in the options menu on the enlarged training display page.
Pure telemetric training
In a pure telemetric exercise neither a profile is displayed nor can such a profile be "processed". Only the HR is displayed and recorded. The exercise ends when the user stop it manually.
Telemetric exercise with profile
This mode can be set in setting 1.25 under Settings → Reha → General → Menu/Functions → Additiona settings for exercise stations → Operations.
The user can also select a profile for the patient, analogous to a real rehabilitation training. The profile has the same characteristics as in normal rehab training, is also created and managed under the module rehab. The only difference to real rehab training is that telemetry cannot control the device (because there is no connection). All possible controls on the training device must be carried out manually by the user. The current values of a profile are also displayed in the F8 table as an aid to "manual control of the devices".